Loading ...
Loading ...
Loading ...
• The iPod® nano (1st Generation) may re-
main in fast forward or rewind mode if it is
connected during a seek operation. In
this case, please manually reset the
iPod®.
• If you are using an iPod® (3rd Generation
with Dock connector), do not use very
long names for the song title, album
name or artist name to prevent the iPod®
from resetting itself.
• Be careful not to do the following, or the
cable could be damaged and a loss of
function may occur:
– Bend the cable excessively (1.6 in (40
mm) radius maximum).
– Twist the cable excessively (more than
180 degrees).
– Pull or drop the cable.
– Do not force the iPod® cable connector
into the device port.
– Close the center console lid on the
cable or connectors.
– Store objects with sharp edges in the
storage where the cable is stored.
– Spill liquids on the cable and
connectors.
• Do not connect the cable to the iPod® if
the cable and/or connectors are wet. It
may damage the iPod®.
• If the cable and connectors are exposed
to water, allow the cable and/or connec-
tors to dry completely before connecting
the cable to the iPod® (wait 24 hours for it
to dry).
• If the connector is exposed to fluids other
than water, evaporative residue may
cause a short between the connector
pins. In this case, replace the cable, other-
wise damage to the iPod® and a loss of
function may occur.
• If the cable is damaged (insulation cut,
connectors cracked, contamination such
as liquids, dust, dirt, etc. in the connec-
tors), do not use the cable. It is recom-
mended that you visit a NISSAN dealer to
replace the cable with a new one.
• When not in use for extended periods of
time, store the cable in a clean, dust free
environment at room temperature and
without direct sun exposure.
• Do not use the cable for any other pur-
poses other than its intended use in the
vehicle.
*iPod® is a trademark of Apple Inc., regis-
tered in the U.S. and other countries.
Bluetooth® streaming audio
• Some Bluetooth® audio devices may not
be recognized by the in-vehicle audio
system.
• It is necessary to set up the wireless con-
nection between a compatible
Bluetooth® audio device and the in-
vehicle Bluetooth® module before using
the Bluetooth® audio.
• Operating procedure of the Bluetooth®
audio will vary depending on the devices.
Make sure how to operate your audio de-
vice before using it with this system.
• The Bluetooth® audio may be stopped
under the following conditions:
– Receiving a call on the Bluetooth®
Hands-Free Phone System.
– Checking the connection to the
hands-free phone.
• Do not place the Bluetooth® audio device
in an area surrounded by metal or far
away from the in-vehicle Bluetooth®
module to prevent tone quality degrada-
tion and wireless connection disruption.
• While an audio device is connected
through the Bluetooth® wireless connec-
tion, the battery power of the device may
discharge quicker than usual.
Monitor, climate, audio, phone and voice recognition systems 4-47
Loading ...
Loading ...
Loading ...