Loading ...
Loading ...
Loading ...
Vitality Series Selectorized Line Owner's Manual: Maintenance 32
Shroud Removal
The Vitality™ Series Selectorized Line includes a shroud that must be removed
to perform the maintenance described in this manual.
Important: Do not remove the shroud while the equipment is in use.
Use the following instructions to remove the shroud:
1. Remove the four M6 * 12 mm buttonhead screws that secure the top cap
to the weight tower frame. Set the screws aside, taking care to keep the
four 7 mm flat washers with them.
2. Lift the outside shroud straight up until its tabs are clear of the shroud clips
mounted on the weight tower uprights, then remove the outside shroud.
3. Repeat the previous step to remove the inside shroud.
Perform the necessary maintenance. When you are finished, replace the
shroud.
4. Align the tabs on both sides of the inside shroud with the slots on the
shroud clips, as shown in the following figure.
5. Press the edges of the shroud in, then down, to secure the shroud.
6. Repeat the previous two steps to mount the outside shroud on the unit.
Important: Just inside the lip of the top cap are ribs that align the top cap with
the outside and inside shrouds. In the following step, make sure that the top
edges of the two shroud panels fit between these ribs and the lip of the top cap.
7. Slide the top cap over the top edges of the two shrouds, making sure that
the top edges of the shrouds align correctly with the top cap.
8. Secure the top cap to the weight tower frame using the buttonhead screws
and flat washers you removed earlier.
9. Wrench-tighten all four screws.
Figure 1: Shroud detail
Loading ...
Loading ...
Loading ...