Loading ...
Loading ...
Loading ...
20
ENGLISH
10.2.1 INTENZA+ installation
> Remove the small white lter in the water tank and store it in a dry place.
Filter setting phase
> Remove the INTENZA+ water lter from its packaging, immerse it vertically in cold
water, with the opening upwards, and slightly press the sides to let air bubbles out.
In order to use the lter correctly, it is necessary to measure the water hardness as
shown in the “5.3.1 Water hardness measurement and setting” chapter.
>
Set the INTENZA+ water lter according to the results of the test, operating on the
lter base:
Letter on the lter Water hardness Test strip squares
A soft water 1 - 2
B hard water (standard) 3
C very hard water 4
> Insert the INTENZA+ water lter in the empty water tank.
>
Push it to the lowest possible point.
>
Fill the water tank with fresh water and restore it to the machine.
Dispense all the water contained in the tank as detailed in the “6.4.1 Hot water
dispensing” chapter.
>
Fill the water tank again.
Machine setting phase during the installation
> Press the MENU button and scroll the menu to go to the ‘INTENZA+ Filter function.’
The default setting is OFF (inactive lter).
>
Press the UP button to select the ON value.
>
Press the OK button to conrm the change.
The modied but unconrmed values will not be stored.
With the ON value the machine is programmed to inform the user that the
INTENZA+ water lter must be replaced.
Once the INTENZA+ lter has been activated, no icon appears on the
display.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3
minutes. At the end, the machine goes back to the main menu.
10.2.2 INTENZA+ replacement
The ‘INTENZA+ water lter to be replaced’ signal is displayed.
Replace the INTENZA+ water lter as described in the “10.2.1 INTENZA+
installation” chapter, performing only the “Filter setting phase” section, and then
proceed as follows.
Machine setting phase during the replacement
> Press the MENU button and scroll the menu to go to the ‘INTENZA+ Filter function.’
The value is ON (active lter).
>
If you wish to replace the INTENZA+ water lter with a new INTENZA+ lter, press
the DOWN button until the RESET value can be selected. Alternatively, if you wish to
remove the INTENZA+ lter without replacing it, select the OFF value.
>
Press the OK button to conrm the change.
The modied but unconrmed values will not be stored.
Selecting RESET, the machine is programmed to manage a new INTENZA+ water
lter, otherwise, selecting OFF, replace the supplied white lter in the tank.
>
Press the ESC button to exit the programming function.
The machine automatically exits the programming mode if no button is pressed for 3
minutes. At the end, the machine goes back to the main menu.
A
B
C
ON
OFF
FILTER
FILTER
ON
OFF
RESET
FILTER
ON
OFF
RESET
FILTER
A
B
C
Loading ...
Loading ...
Loading ...