Loading ...
Loading ...
Loading ...
14
ENGLISH
7.4 Milk frother cleaning
7.4.1 Milk frother cleaning cycle
It is important to clean the milk frother after every use, in order to promote hygiene
and guarantee the perfect thickness of the frothed milk.
The milk frother must be installed.
>
Press the STEAM button to dispense steam for a few seconds.
>
To stop dispensing, press the OK button.
Burning hazard! The steam wand and the milk frothed could be hot.
>
Remove the milk frother and wash it with lukewarm water.
7.4.2 Weekly cleaning of the milk frother components
The weekly cleaning is more thorough.
1. Milk frother
2. Rubber grip
Burning hazard! If the machine has been recently used the steam wand and the milk
frothed could be hot.
>
Remove the milk frother (1) and wash it with lukewarm water.
>
Remove the rubber grip (2) and wash it with fresh water.
>
Clean the steam wand with a wet cloth.
>
Perform the previous operations in reverse order and reassemble the milk frother.
The rubber grip on the steam wand must be properly inserted, without going beyond
its seat, otherwise the milk frother does not operate correctly.
7.5 Descaling cycle
When the CALC CLEAN symbol is displayed, it is necessary to descale the machine.
If this is not done, the machine may stop working correctly: in this case, repairs are
NOT covered by the warranty.
The descaling cycle has a duration of roughly 30 minutes. It consists of a proper
cleaning cycle, with the Gaggia descaling product, followed by a rinse cycle.
Do not remove the brew group during the descaling process.
Do not drink the descaling solution or the products resulting from the descaling cycle.
Use exclusively the Gaggia descaling solution. The use of other products may damage
the machine and leave residue in the water. The Gaggia descaling solution is sold
separately. For further details please refer to the “10.1 Maintenance products” chapter.
Preparation phase
> Press the side buttons.
>
Remove the drip tray.
>
Remove the coffee grounds drawer and empty it.
>
Empty and wash the drip tray.
>
Restore all the components.
>
Place a large container (1.5 l) under the dispensing spout.
>
If installed, remove the milk frother from the steam wand.
Descaling phase
If the INTENZA+ water lter is present, extract the lter from the water tank and
replace it with the original small white lter.
>
Pour all the descaling solution in the water tank.
>
Then ll the tank with fresh water to the CALC CLEAN level.
>
Put the water tank back in the machine.
2
1
START
CALC
CLEAN
MAX
CALC
CLEAN
AX
CALC
CLEAN
Loading ...
Loading ...
Loading ...