Loading ...
Loading ...
Loading ...
Frequently asked questions
101
With the help of the following guide, minor faults in the performance of the appliance,
some of which may result from incorrect operation, can be corrected without contacting
the Service Department.
Please note that a call-out fee will be applied to unnecessary service visits where the prob-
lem could have been rectified as described in these operating instructions.
Repair work to electrical appliances must only be carried out by a suitably qualified
person in strict accordance with current local and national safety regulations. Repairs
and other work by unqualified persons could be dangerous. The manufacturer cannot be
held liable for unauthorized work.
Technical problems
Problem Possible cause and solution
The display remains dark
and the Start/Stop light
does not flash after the
dishwasher was turned on
using the button.
The dishwasher is not plugged in.
Plug the power cord into an electrical outlet.
The circuit breaker was tripped.
Activate the fuse
(see data plate for minimum fuse rating).
The dishwasher stops dur-
ing a program.
The circuit breaker has tripped.
Reset the circuit breaker (see data plate for the correct
fuse rating).
If the circuit breaker trips again, contact Miele Customer
Service.
One of the following fault
messages is displayed:
Before remedying the fault:
Turn the dishwasher off using the button.
Check water intake There is a problem with the water intake.
Open the faucet all the way.
Clean the filter in the water inlet (see "Cleaning and
care").
Fault 403-405 If Check water intake has appeared in the display, the con-
trols will check the water intake every 30seconds. If no wa-
ter has entered the dishwasher after three attempts, one of
these fault numbers appears in the display and the program
will be canceled.
Open the water supply valve all the way.
Turn the dishwasher back on.
Select the desired program.
Press the Start/Stop button.
Fault 406-408 Water inlet fault.
One of these numbers will appear in the display if the flow
pressure is too low and the program will be cancelled.
The flow pressure at the water intake point is too low
(see "Technical data"). Contact Miele Service for advice.
Loading ...
Loading ...
Loading ...