Loading ...
Loading ...
Loading ...
Using Memory and PC
Saving and Recalling
75
All memories in use
If no free memory locations are available a message pops
up that proposes to you to overwrite the oldest data set.
Do one of the following:
If you don’t want to overwrite the oldest data set,
- press
F3
, the delete one or more memory
locations, and save again.
If you want to overwrite the oldest data set,
- press
F4
.
Editing names
To name the screen+setup according to your own
preferences, continue from step 4 as follows:
5
F1
Open the EDIT NAME menu.
6
F2
Skip to a new character position.
7
ENTER
Select another character and press
ENTER to accept your choice.
Repeat 6 and 7 until done.
8
F1
Accept the name and return to the
SAVE AS menu.
9
ENTER
Highlight OK SAVE to save the
actual screen using the edited
name.
To modify the default name generated by the test tool,
continue from step 8 as follows:
9
ENTER
Highlight SET DEFAULT to save
the new default name.
10
ENTER
Highlight OK SAVE to save the
actual screen using the new default
name.
Notes
The ‘record+setup’ memory locations store
more than just what is visible on the screen.
In TrendPlot or Scope Record mode the full
recording is saved. In scope mode you can
save all 100 replay screens in a single
record+setup memory location. The table below
shows what you can store for the various test
tool modes.
To save a TrendPlot press STOP first.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct
.com
Loading ...
Loading ...
Loading ...