Loading ...
Loading ...
Loading ...
210
Press in the lower right corner to switch to decode channels , tap or to enable decoding,
open bus configuration menu, select bus type, there are seven bus types: UART (RS232/RS422/RS485), LIN, CAN,
SPI, I2C, ARINC429, 1553B, where channels and can be used for decoding simultaneously. Open the
trigger setting menu, choose an appropriate trigger type, the corresponding bus trigger type and trigger mode can be
set when the bus trigger is selected, and the serial bus is displayed in graphic form.
In the serial bus decode mode, if it is screen rolling in other modes, the time base is automatically adjusted to 1ms
when switching to serial decode (the maximum time base supported by the serial decode mode is 100ms); in Zoom
mode, the enlarged signal can be decoded and displayed. The normal display window supports a maximum time
base of 100ms. When decoding is enabled, clicking “AUTO” will set the trigger type to be the same as the decode
channel bus type. The bus type selection menu is shown in Figure 12-1:
Loading ...
Loading ...
Loading ...