Loading ...
Loading ...
Loading ...
bluestarcooking.com 15
Installaon Instrucons
Step 4 — Install the An-Tip Bracket
Important: An an-p bracket is required for all ranges. You
must install the an-p bracket before installing the range to
reduce the risk of pping the appliance. Use the an-p
bracket provided to install and secure your range in place.
Contact a qualied oor covering installer for the best
procedure for drilling mounng holes through your oor
covering or a contractor for aaching to the wall.
1. Use the holes provided in the bracket to aach the bracket
to the rear wall or oor. The bracket should overhang the
base of the range as shown in the following illustraon.
2. Put the bracket 1 1/2” (38.1 mm) from the le side of the
edge of the range and ush against the wall with the
fastener hole closest to the wall.
IMPORTANT: Should you move the range, remove the an-p
bracket before the move, then reinstall the bracket with the
range in the new locaon. Do not operate the range without
the an-p bracket engaged.
IMPORTANT : Si vous déplacez la cuisinière, rerez le support
an-basculement avant le déplacement, puis réinstallez le
support avec la cuisinière au nouvel emplacement. Ne faites
pas fonconner la cuisinière sans que le support an-
basculement ne soit engagé.
Step 5 — Connect Electrical Supply
Observe all local and other codes regarding electrical
connecons.
Important: save these instrucons for the local electrical
inspector’s use.
1. Remove the electrical box cover to expose the terminal
block. Route the wires through the strain relief (not
supplied) through the boom of the electrical enclosure.
The terminal block allows for a 4-wire installaon.
Four Wire Installaon
2. If a four wire connecon is used, leave the metal ground
strap in its inial posion.
3. Connect green/ground to G.
4. Connect white/neutral to N.
5. Connect red to L1.
6. Connect black to L2.
lmportant: All electrical wiring should be free and clear.
Wires or cables should not be pinched or otherwise
obstructed.
7. Tighten the screws on the strain relief and aach the
electrical cover.
8. If the power cord (supplied with Canadian models) is used,
locate the electrical outlet and plug the range into the
outlet.
Hole to fasten
to wall
Hole to fasten
to oor
Place against
the wall
Hole to fasten
to oor
Bracket should be over
the appliance base
when the range is
pushed into its nal
posion.
Verify that the an-p device is engaged by slowly aempng
to lt the range forward. If you encounter immediate
resistance, the an-p device is engaged.
WARNING
AVERTISSEMENT
Vériez que le disposif an-basculement est engagé en
essayant lentement d'incliner la cuisinière vers l'avant. Si vous
rencontrez une résistance immédiate, le disposif an-bascule
est enclenché.
This appliance must be grounded. Do not cut, remove, or
disregard the grounding wire in this appliance. If the appliance
is not grounded, severe shock hazards can exist.
WARNING
Cet appareil doit être mis à la terre. Ne coupez pas, ne rerez
pas et ne négligez pas le l de mise à la terre de cet appareil. Si
l'appareil n'est pas mis à la terre, de graves risques
d'électrocuon peuvent exister.
AVERTISSEMENT
Loading ...
Loading ...
Loading ...