Loading ...
Loading ...
Loading ...
overview
14_ overview
SNP-3120V
Item Description
Surface Mount
Bracket
Used to install the camera directly on the ceiling.
After separating this cover, mount this bracket on to ceiling.
b
Main unit Main unit includes the lens, switch board, PCB boards and screws.
c
Dome Cover Dome cover for the lens and unit protection.
SD Memory Card
Compartment
Compartment for the SD memory card.
Audio Audio I/O port.
Heater
Activated when the ambient temperature is under 5ºC to prevent the dome
cover from being covered with frost.
Video, RS-485, Power Used to connect monitor, RS-485 device or power.
ID setup switch Used to setup the camera ID or communication protocol.
Reset Button
Resets the camera settings to the default. Press and hold it for about 5
seconds to turn off the system indicator and restart the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Alarm In / Out
terminals
Used to connect alarm in/out terminal block.
Network port Used to connect a PoE or LAN cable.
❖
Loading ...
Loading ...
Loading ...