Loading ...
Loading ...
Loading ...
DS-K1T8003 Series Fingerprint Access Control Terminal User Manual
72
If you enable this function, you can input the card No. by pressing the key.
4. Click OK.
5. Optional: Click Copy to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Configure Parameters for Door
After adding the access control device, you can configure its access point parameters.
Steps
1. Click Access Control → Advanced Function → Device Parameter.
2. Select an access control device on the left panel, and then click to show the doors of the
selected device.
3. Select a door to show its parameters on the right page.
4. Edit the door or floor parameters.
Note
● The displayed parameters may vary for different access control devices.
● Some of the following parameters are not listed in the Basic Information page, click More to
edit the parameters.
Name
Edit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit Button Type
You can set the exit button as remaining closed or remaining open. Usually, it is remaining
open.
Door Locked Time
After swiping the normal card and relay action, the timer for locking the door starts working.
Door Left Open Timeout Alarm
The alarm can be triggered if the door has not been closed in a configured time period. If it is
set as 0, no alarm will be triggered.
Super Password
The specific person can open the door by inputting the super password.
Duress Code
The door can open by inputting the duress code when there is duress. At the same time, the
Loading ...
Loading ...
Loading ...