Loading ...
Loading ...
Loading ...
DS-K1T8003 Series Fingerprint Access Control Terminal User Manual
114
file, upgrade the device, etc.
Steps
1. Click Maintenance and Management → Group to enter the device list.
2. Click to enter the remote configuration page.
3. Click System → System Maintenance.
4. Maintain the device.
Reboot
The device starts rebooting.
Restore Default
Restore the device settings to the default ones, excluding the IP address.
Restore Part of Settings
Restore all settings except communication settings and the remote user settings to default
ones.
Restore All
Restore the device parameters to the default ones. The device should be activated after
restoring.
Import Configuration File
Import the configuration file from the local PC to the device.
Note
The configuration file contains the device parameters.
Export Configuration File
Export the configuration file from the device to the local PC.
Note
The configuration file contains the device parameters.
5. Remotely upgrade the device.
1) In the Remote Upgrade part, select an upgrade type.
Note
● Only the card reader that connected via RS-485 protocol supports upgrading.
● If you need to upgrade the device system, make sure the controller version and the
extension module's version are the same. Here the controller refers to the TX1 system
while the extension module refers to the MCU system.
2) Click Browse to select an upgrade file.
3) Click Upgrade to start upgrading.
Loading ...
Loading ...
Loading ...