Loading ...
Loading ...
Loading ...
DS-K1T8003 Series Fingerprint Access Control Terminal User Manual
115
Note
Do not power off during the upgrading.
8.5 Configure RS-485 Parameters
You can set the RS-485 parameters including the baud rate, data bit, stop bit, parity type,
communication mode, work mode, and connection mode.
Steps
1. Click Maintenance and Management → Device to enter the device list.
2. Press CTRL and click to enter the remote configuration page.
3. Click System → RS-485 Settings to enter the Configuring the RS-485 Parameters tab.
4. Select the serial No. of the port from the dropdown list to set the RS-485 parameters.
5. Set the baud rate, data bit, the stop bit, parity, flow control, communication mode, working
mode, and the connection mode from the dropdown list.
6. Click Save and the configured parameters will be applied to the device automatically.
Note
After changing the working mode, the device will be rebooted. A prompt will be popped up
after changing the working mode.
8.6 Manage User
Steps
1. Click Maintenance and Management → Device to enter the device list.
2. Press CTRL and click to enter the remote configuration page.
3. Click System → User.
4. Click Add to add the user (Do not support by the elevator controller.).
5. Optional: Select a user in the user list and click Edit to edit the user.
You are able to edit the user password, the IP address, the MAC address and the user
permission.
6. Click OK.
8.7 Set Security
Steps
1. Click Maintenance and Management → Device to enter the device list.
Loading ...
Loading ...
Loading ...