Loading ...
Loading ...
Loading ...
24
Text in control panel
Explanation
Please reboot to start the
firmware update
Restart the lawn mower.
Work interrupted, please retry
Rain sensor activated
Rain sensor is activated.
Mower in the station
Mower in the station.
Mower is not in the station
Mower is not in the station, if necessary, place the lawn mower in
the station.
Press “START” key to start
Press the START button (3).
Duration at least 30 minutes
Indication of the time needed.
searching for signal...
Lawn mower searches for its signal.
Copy file, please wait
Please wait for the copying process.
Please turn it off
Switch off lawn mower.
Update fail
If necessary, carry out the update procedure again.
Error
See chapter “reading out the work and error log”.
Cutting motor stall
See chapter “Removing blockages”; Check blades for foreign
bodies/defects; If necessary, contact customer service centre.
Left motor stall
Please replace the battery
Replace battery.
Battery damaged
Battery abnormal
Battery temperature too low
(discharge)
Cancel charging process.
Battery voltage high
Battery voltage too high.
Battery high temp/high temp
Battery has a high temperature, Cancel charging process.
High charge current
Cancel charging process, check input current.
High charge voltage
Cancel charging process, check input voltage.
Mower lifted
Lawn mower was lifted.
Mower overturned
Set lawn mower upright and restart.
Mower trapped
Clear the lawn mower and restart.
Mower tilted
Set lawn mower upright and restart.
Motor over temperature
Switch off the lawn mower and let it cool down.
Motor error
Contact customer service centre.
Em-sensor disconnect
Hall sensor failure
Hardware error
Ladung abnormal
Charging abnormal
Battery discharge error
Inertial measurement unit
(IMU) error
Motor disconnect
Motor hall error
Motor over-current
Motor stall
Right motor stall
Rain sensor failure
Loop sensor failure
Loading ...
Loading ...
Loading ...