Loading ...
Loading ...
Loading ...
18
● If the mower is outside the boundary wire (11) or on the charging station and you select “Spot
mode”, this display shows “Place inside the boundary and retry”. Set the mower down inside the
boundary wire (11) and next to the charging station and restart “Spot mode”.
● If the battery charge level is less than 30 %, the display shows “Low battery voltage” after 2
seconds. Charge the lawn mower before you can start mowing with the fixed point.
Back To The Charging Station
1. When the device is in standby state, press and hold the HOUSE button (4) for about 3 seconds.
The display (10) shows “Close the cover to start”.
2. Close the cover (1) and the mower moves to the charging station. It then begins to charge there.
Manually Interrupting/Starting The Operating Cycle
Interrupting operation
Press the STOP button (9) to stop the mower during operation.
Starting /resuming operation
1. Open the cover (1). Confirm with the OK button (7).
2. Unlock the display (10) with the 4-digit PIN.
3. Press the START button (3).
4. Close the cover (1) again.
The lawn mower starts the set operating cycle or resumes its previous activity without interruption.
NOTE: Regular mowing stimulates the grass to an increased leaf formation, while at the same time
killing weeds. As a result, the lawn becomes denser after each mowing and an evenly resilient lawn is
created.
The first cut takes place roughly in April when the grass is about 2.7 - 3.3inch high. During the main
growing season, the lawn is mowed at least once a week.
Setting The Date And Time
1. Open the cover (1).
2. Unlock the display (10) with the 4-digit-PIN. Press the OK button (7) to enter the main menu.
3. Use the arrow buttons (6) to select “Settings”. Confirm the selection with the OK button (7).
4. Use the arrow buttons (6) to select "Date&time”. Confirm the selection with the OK button (7).
5. Change the date and time with the arrow button (6) .The individual positions can be navigated with
the OK button (7) (skip the right).
NOTE: The correct date and time setting is required to ensure the correct functions of the operating
time settings.
Setting The Rain Sensor
WARNING :We advise against having the lawn mower operate while it is raining.
Never operate the lawn mower during storms and make sure to disconnect the charging station
from the mains. If the rain sensor is switched on, the lawn mower returns to the charging station when
it rains.
1. Open the cover (1).
2. Unlock the display (10) with the 4-digit-PIN. Press the OK button (7) to enter the main menu.
Loading ...
Loading ...
Loading ...