Rigol DHO924 DHO900 series user manual

Loading ...

Function/Arbitrary Waveform Generator (for

DHO914S and DHO924S only)

The DHO914S and DHO924S series have a standard built-in 25 MHz Function/

Arbitrary Waveform Generator (AFG), which integrates the signal source and the

oscilloscope into one, providing great convenience for engineers who need to use the

signal source and oscilloscope at the same time. This chapter introduces how to use

the built-in AFG.

14.1 To Output Basic Waveforms

Press the front-panel key or click or tap the AFG label at the bottom of the

screen to enable the AFG output. Press the

key or click or tap the AFG label

again to enter the AFG setting menu, as shown in the figure below.

Figure 14.1 AFG Setting Menu

The built-in Function/Arbitrary Waveform Generator can output a variety of basic

waveforms, including Sine, Square, Ramp, DC, Noise, and Arb. You can set the basic

waveform parameters according to the following section and then click or tap the

Output on/off switch to enable/disable the output of the [AFG OUT] connector on

the rear panel.

14.1.1 To Output Sine

In the AFG setting menu as shown in

Figure 14.1

, click or tap the Function drop-

down button to select "Sine". At this time, you can set the parameters for the sine

waveform.

Function/Arbitrary Waveform Generator (for

DHO914S and DHO924S only)

DHO900 User Guide

170

Loading ...

Rigol DHO924 oscilloscope