Loading ...
Loading ...
Loading ...
TIi IIII.ITY I;)IVI©!
a
ALL RANGES
CAN TIP
iNJURY TO PERSONS
COULD RESULT
INSTALL ANT!-TIP
DEVICES PACKED
WITH RANGE
SEE INSTALLATION
INSTRUCTIONS
F_EMOVE AILL PARTS FROM THE PLASTIC BAG
ATTACHED TO THE BACK OF THE RANGE APJD
gAVE PAC_GIHG TAPE,
1) Beiore placing the range in _he counter, notice the
location of the stability bracket that is attached to the
back of the range, This location should work for
most Insta!latlons. However, it may be more conven-
ient to hook the stability chain to the range when the
stability bracket is at{ached to the upper set of holes
in the back of the range (See Fig. 1). The upper set of
holes are intended for use with a backspiash kit, If a
backsplash kit Is being used, the stability bracket
can be relocated and put on at the same time as the
backsplash kit. if the backsplash ts not being used,
make sure that there are no countertop structural
supportswhich will Interferewiththestabilty bracket
when located In the upper set of holes.
2) Fasten one end of the stabillty chaln to the floor or the
wall with the long screw and washer supplied (See
Fig. 2), Make certaln the screw Is going into thewall
plate or stud at the base of the wall (See Fig. 3).
Whether you attach the chain to the wall or floor, be
certain there are no electrical wires or plumbing tn
this area, and that the screw penetrates the wood or
other baseboard at Jeast 3/4", ._ttach the stability
chain in a location which will alow the chain to be in
line wlh tha bracket side to side as much as possible
when attached to the range. Test by tugging to see
if the chain ts securely fastened.
3) Using the packaging tape, temporarily attach the
loose end of the chain to the rear of the countertop
(See Fig. 4)°
4) Place the range in the counter culout leaving just
enough rool nbetween _.heback of the r_nge ar,dthe
wall to r_ch the stabllty bract, eL
5) Hook _he ;oos# end of the ch_i_, onto _he brac_÷t by
slipping the nearest link of ',he Chall t_'_tOthe slot in
the bracket (See Fig, t), ltak÷ s_r_.the chain is puled
as tight as possible and that there is no _+×c_ssslack
In the chain when it is attacl_ed to the bracket,
*_}{CeSS slack in _he chair, could alH_)_,_'_he
r_nge to lip over.
6) Slide the range all the way back into the countero
Once the range Is in place, it is normal to have a small
_mount of slack in the chaln.
BRACKET
OPTIONAl..
LOCATION
CHAIN +-
_'_ BACKGUARD
I I _" (some models)
¢
MAINBACK
(Elsctrfc model shown;
Opposite side used for Gas models)
BRACKET
FACTORY
LOCATtO_
Fig. 1
CHAIN
AND Fig_ 2
CHAIN_ I I WALL
LONG \x,_ PLAT=
SCREW _, II ,"=
WASHER I I /
TAPE
Fig. 3
Fig, 4
NEINS28-2
Loading ...
Loading ...
Loading ...