Loading ...
Loading ...
Loading ...
94
Cellular settings
Select Ite0 and Enable to enable the network. This function is enabled by default.
Configure parameters.
Table 5-17 4G parameters
Parameter Description
NetAccess
When the device is connected to a private network, select the NetAccess
check box, enter APN name and select authentication mode. If PAP or CHAP is
selected for authentication mode, enter user name and password, and then
the device is automatically connected to the private network.
WLAN type
When enabled, the network type is displayed, which is used to distinguish
between the 4G modules of different communication operators, such as
TD-LTE.
APN
When enabled, the access point of the communication operator is displayed.
To manually set up APN, select Customized.
AUTH
Includes PAP, CHAP, and NO_AUTH protocols. The system automatically
recognizes and displays the enabled protocol.
Dial No. Enter the dial number provided from the communication operator.
User name
This parameter needs to be set up when AUTH is set to PAP or CHAP.
The system automatically recognizes the user name and password.
Password
WLAN status
After successful dial-up, all relevant information is displayed without any setup
needed. Such information includes module state, SIM state, PPP state, working
mode, IMSI, IMEI, IP address, subnet mask, gateway, and module type.
Wireless Signal
Click Search to search for wireless signals.
Click OK.
After successful connection, the obtained IP address is displayed.
5.6.4 Configuring Email Settings
You can configure the email settings to enable the system to send an email as a notification when
there is an alarm event occurs, such as video detection or abnormality.
Loading ...
Loading ...
Loading ...