Loading ...
Loading ...
Loading ...
en Scales
52
10.2 Weighing ingredients
Requirements
¡ The bowl is inserted or an access-
ory is fitted.
¡ The rotary switch is set to
.
¡ The display is activated.
1. Press
and do not touch the ap-
pliance again.
a The scales will be calibrated.
a The display shows "- - - - -".
2. Wait for calibration to finish.
a The display shows "0g" or
"0.00lb".
3. Add the required ingredient.
a The display shows the weight.
4. To weigh further ingredients, select
one of the following options:
‒ Add further ingredients and read
off the total weight.
‒ Repeat the process and weigh
the ingredients individually.
10.3 Presetting the weight
Requirements
¡ The bowl has been inserted.
¡ The rotary switch is set to
.
1. If the display is switched off, press
any button.
2. Press
and do not touch the ap-
pliance again.
a The scales will be calibrated.
a The display shows "- - - - -".
3. Wait for calibration to finish.
a The display shows "0g" or
"0.00lb".
4. Press
.
a The display shows "100g" or
"0.20lb".
5. Use
or to set the required
weight.
6. Add the required ingredient to the
bowl.
a The display shows the quantity by
which the weight is short, e.g.
65g.
a A recurring signal tone will sound
from a short weight of 40g or
0.08lb.
7. Continue adding the ingredient
little by little.
a The lower the weight that is short,
the faster the signal tone will
sound.
a When the preset quantity is
reached, the signal tone will stop.
8. Note:If the preset quantity is ex-
ceeded, the signal tone will sound
continuously. The display shows
the excess weight added as a neg-
ative value, e.g. -40g.
Take the excess weight added
away again.
9. To end weighing, press and hold
or start processing.
Tip:You can change the volume of
the signal tones at any time.
→"Overview of basic settings",
Page49
10.4 Resetting scales
If an error message appears or unac-
customed measured values are dis-
played, reset the scales.
1. Press and hold
.
a The display shows "OptiMUM"
2. To restart the scales, press
.
Note:If the scales still do not work
properly, disconnect the appliance
from the power supply for a while
and then start the scales again.
Loading ...
Loading ...
Loading ...