Loading ...
Loading ...
Loading ...
Special Recording Modes
114
Interval Recording Mode
Set the interval in advance. At each interval, the camera will record one frame. Sound is not recorded in this
mode.
Activating and Configuring
1 Open the [Recording Mode] submenu.
> [
Æ
! Recording/Media Setup] > [Recording Mode]
2 Select [Interval Recording] and then press the joystick.
• [INT STBY] appears at the top of the screen (with [INT] flashing).
3 Open the [Recording Interval] submenu.
> [
Æ
! Recording/Media Setup] > [Recording Interval]
4 Select the desired interval and then press the joystick.
• You can select one of 7 interval settings from 1 second to 10 minutes.
Recording
1 Press the REC button to begin recording.
• The camera automatically records one frame at the specified interval.
• The tally lamp illuminates.
• [INT STBY] changes to [
Ü
INT REC] while recording frames, and [
Ü
INT] and a countdown until the next
recording between recordings.
2 Press the REC button again to stop recording.
• All of the recorded frames are joined together into one clip.
• The tally lamp goes out and [INT STBY] appears at the top of the screen (with [INT] flashing).
3 When you have finished recording, turn off the special recording mode.
• Repeat steps 1 and 2 of the previous procedure selecting [Normal Recording] instead.
NOTES
NOTES
• You can use only one special recording mode at a time.
• The interval cannot be changed while recording.
• Some frames at the point the recording was stopped may be recorded and added to the end of the clip.
• If the system frequency, frame rate or resolution/color sampling is changed, interval recording mode will be
canceled and [Recording Interval] will return to its default value.
• About the time code during interval recording mode:
- The time code mode can be set to [Regen.], or to [Preset] with [Rec Run] running mode.
- If the time code running mode was set to [Free Run], the time code running mode will be changed
automatically to [Rec Run] when interval recording is activated.
- When the special recording mode is deactivated, the time code running mode will return to its previous
setting.
- The time code signal will not be output from the SDI terminal or HDMI OUT terminal.
Loading ...
Loading ...
Loading ...