Loading ...
Loading ...
Loading ...
ADVANCED EMBROIDERY
77
3
k
Remove excess urethane foam from around the
pattern.
• Carefully remove the excess urethane foam since
pulling on a thread will cause a thread loop to form
on the right side of the fabric, spoiling the clean
finish.
By using the Embroidery Crosshair Positioning Laser function,
the embroidering position can easily be aligned. This is useful
when embroidering in an area where it is necessary to align
the pattern, as shown below.
a
Use a chalk pencil to mark the desired embroidering
position.
The line drawn for the reference direction should be
longer.
1 Chalk pencil mark
b
Hoop the fabric in the embroidery frame.
Note
• If the urethane foam sticks out between stitches,
heat it with an iron to shrink it and to improve the
finish. Apply steam with a steam iron in order to
avoid crushing the embroidery. If your iron does
not have a steam function, apply heat from a
distance to avoid direct contact with the
embroidery.
• If the iron temperature is too high, the thread or
fabric may melt.
USING THE EMBROIDERY
CROSSHAIR POSITIONING LASER
FUNCTION TO ALIGN THE
EMBROIDERING POSITION
Memo
• If the desired position of the pattern can be clearly
established, such as when embroidering along a
pocket, it is not necessary to mark the position with
a chalk pencil.
Note
• When hooping the fabric in the embroidery frame,
make sure that the embroidery pattern will fit within
the embroidering area of the frame being used.
1 Embroidering area
2 Embroidery pattern size
3 Chalk pencil mark
a
a
b
c
Loading ...
Loading ...
Loading ...