Loading ...
Loading ...
Loading ...
76
Making 3D font embroidery with urethane
foam
You can make 3D font embroidery by using urethane foam for
embroidery.
a
Touch .
b
Touch the 3D font.
c
Select the character category and then select the
characters. (page 32)
d
Touch .
The pattern editing screen appears.
e
Follow the procedure from step d to g of
“Embroidery patterns” on page 29.
f
Cut the urethane foam so that it will be larger than the
3D font pattern.
• Refer to the pattern size in the screen to determine the
required size of urethane foam, and then cut the foam
with a little excess.
g
Use tape to secure the urethane foam.
• Do not apply tape where it will overlap a pattern.
• Firmly secure the urethane foam with tape so that it
does not shift during embroidering.
h
Touch to check the position of the pattern and
make sure it does not extend out of the urethane foam.
(page 61)
i
Touch , and then press the “Start/Stop”
button to start embroidering.
j
When embroidering is finished, remove the tape
securing the urethane foam.
(page 22):
An instruction video is available for this topic.
Note
• Use urethane foam with a thickness no more than 3
mm (approx. 1/8 inch).
Note
• Basting around the pattern will secure the urethane
foam more firmly during embroidering. After
completing step
e, touch in the embroidering
screen. After adding basting, continue with step
f
to finish embroidering.
Note
• Do not apply tape where it will overlap a pattern.
Note
• Adjust the thread tension so that the bobbin thread
is tighter (page 81) and the upper thread is looser
(page 82). If the upper thread is too tight, the
bobbin thread will be visible from the right side of
the fabric, and the embroidery will not have a clean
finish.
Loading ...
Loading ...
Loading ...