Loading ...
Loading ...
Loading ...
BASIC EMBROIDERY
23
2
Basic embroidering procedures are described below.
Check the overall procedure below, before operating the
machine.
When the machine is purchased, only the bobbin case is
installed in the hook. Insert a bobbin wound with bobbin
thread for embroidering.
Removing the bobbin case
a
Open the hook cover.
Pull the hook cover toward you.
b
Pull the thread picker toward you if it was not pulled
toward the front.
To gain access to the bobbin case easily, pull the thread
picker toward front.
Chapter 2
BASIC EMBROIDERY
BASIC PROCEDURES
Step Operation
Reference
Page
1 Turn on the machine. 18
2 Install the bobbin. 23
3 Select an embroidery pattern. 28
4 Edit the embroidery pattern. 35
5 Check the previewed image. 47
6
Hoop the fabric in the embroidery
frame.
48
7
Attach the embroidery frame to the
machine.
52
8 Specify the embroidering settings. 56
9 Checking the position of the pattern. 60
10 Thread the upper threads. 61
11
Touch the “Start/Stop” button to start
embroidering.
67
12 Remove the embroidery frame. 68
13 Turn off the machine. 18
INSTALLING THE BOBBIN
IMPORTANT
• Be sure to use prewound bobbins (Fil-Tec/
TRU-SEW POLYESTER “Filaments”), the
included metal bobbins or bobbins designed
specifically for this machine.
Note
• Before starting to embroider make sure that there
is enough bobbin thread for the pattern.
• Make sure to clean the bobbin case every time the
bobbin is changed. (page 93)
1 Thread picker
Memo
• Thread picker is a device that is used to hold the
thread when beginning to embroider or when
trimming the thread.
Loading ...
Loading ...
Loading ...