Loading ...
Loading ...
Loading ...
48 GETTING TO KNOW YOUR VEHICLE
RELEARN PROCEDURE
For vehicles equipped with a power sliding roof, there is a
relearn procedure that allows you to calibrate the power
roof when the “Express Mode” stops working. To reset the
power sliding roof, follow these steps:
1. Place the ignition in the RUN position, and start the
vehicle.
NOTE:
The engine must be running to perform the relearn
procedure.
2. Ensure the power sliding roof is in the fully closed
position.
3. Push and hold the open/close switch for 10 seconds.
This will put the power sliding roof into calibration
mode.
4. Continue holding down the close button while the
top goes fully open and then back to fully close.
5. Once the power sliding roof has stopped in the
fully closed position, release the open/close switch.
The power sliding roof is now reset and ready to use.
NOTE:
If the open/close switch is released anytime during the
relearning process, the relearn may not be complete, and
the procedure must be repeated.
HOOD
TO OPEN THE HOOD
To open the hood, two latches must be released.
1. Pull the release lever located underneath the
driver’s side of the instrument panel.
Hood Release Lever
2. Move to the outside of the vehicle and push the
safety latch release lever toward the passenger side
of the vehicle. The hood release lever is located
behind the center front edge of the hood.
Safety Latch Release Lever Location
3. Remove the support rod from the locking tab and
insert it into the seat located on the underside of the
hood. Be sure the rod is locked into position.
Hood Prop System
1 — Locking Tab
2 — Support Rod
3 — Support Rod Seat
23_FD_OM_EN_USC_t.book Page 48
Loading ...
Loading ...
Loading ...