Loading ...
Loading ...
Loading ...
206 IN CASE OF EMERGENCY
To use your Semi-Auto Kit, proceed as follows:
1. Stop the vehicle in a position where you can repair
the tire safely. You should be as far as possible from
the side of the road, and in a position that is not
dangerous for oncoming traffic. Activate the Hazard
Warning Flashers to make other drivers aware of
your presence.
2. Verify that the valve stem (on the wheel with the
deflated tire) is in a position that is near to the
ground. This will allow the Semi-Auto Kit hoses to
reach the valve stem and keep the tire repair kit flat
on the ground.
3. Place the gear selector to PARK (P).
4. Apply the Electric Park Brake and cycle the engine
OFF.
5. Insert the sealant cartridge containing the sealing
fluid in the proper compressor holder, pushing down
hard. Unscrew the tire valve cap, take out the filler
tube and tighten the fitting on the tire valve.
Attaching Filler Tube To Deflated Tire
6. Make sure the compressor is switched off.
7. Insert the plug into the vehicle’s center console
power outlet, then start the engine.
12 Volt Power Outlet
8. Switch the compressor on.
9. Inflate the tire to the pressure indicated on the tire
placard, located on the driver’s side B-pillar or the
rear edge of the driver’s side door Ú page 254. In
order to obtain a more precise reading, check the
pressure value on pressure gauge with the
compressor off.
Air Compressor
1 — Sealant Cartridge
2 — Filler Tube
5 — Pressure Gauge
6 — Power Switch
23_FD_OM_EN_USC_t.book Page 206
Loading ...
Loading ...
Loading ...