Loading ...
Loading ...
Loading ...
IN CASE OF EMERGENCY 207
10. If the pressure is not at least 26.1 psi (1.8 bar) after
15 minutes, disengage the compressor from the
valve and power outlet. Then, move the vehicle
forwards approximately 33 ft (10 m) in order to
distribute the sealant inside the tire evenly, and then
repeat the inflation operation.
11. If you still cannot obtain a pressure of at least 26 psi
(1.8 bar) within 15 minutes of turning the compressor
on, do not drive the vehicle, and contact an
authorized dealer.
12. Drive the vehicle for about 5 miles (8 km), stop, apply
the electric park brake, and recheck the tire pressure.
13. If the pressure is less than 26 psi (1.8 bar),
DO NOT
drive the vehicle, and see an authorized dealer.
14. If a pressure value of at least 26 psi (1.8 bar) is
detected, restore the correct pressure (with engine
running and electric park brake applied), and drive
immediately with great care to an authorized dealer.
15. Apply the adhesive label from the sealant bottle
where it can be easily seen by the driver as a
reminder that the tire has been treated with a
Semi-Auto Kit, as well as not to exceed the speed
restriction for the treated tire.
CHECKING AND RESTORING TIRE
P
RESSURE
The compressor can also be used to check and, if
necessary, restore the tire pressure.
Proceed as follows:
1. Plug the power cord in the vehicle’s power outlet.
2. Release the quick connector and connect it directly to
the valve of the tire to be inflated.
3. Push the air release button.
Air Compressor Components
WARNING!
The Semi-Auto Kit is not a permanent flat tire repair.
Have the tire inspected and repaired or replaced after
using the Semi-Auto Kit. Do not exceed 50 mph
(80 km/h) until the tire is repaired or replaced. Failure
to follow this warning can result in injuries that are
serious or fatal to you, your passengers, and others
around you. Have the tire checked as soon as possible
at an authorized dealer.
WARNING!
Do not adhere the speed restriction sticker to the
padded area on the steering wheel. Adhering the speed
restriction sticker to the padded area on the steering
wheel is dangerous because the air bag may not
operate (deploy) normally resulting in serious injury. In
addition, do not adhere the sticker to areas where
warning lights or the speedometer cannot be viewed.
6 — Quick Connector
7 — Air Release Button
8 — Power Cord
9 — Release Button
7
23_FD_OM_EN_USC_t.book Page 207
Loading ...
Loading ...
Loading ...