Loading ...
Loading ...
Loading ...
40
31-1000600 Rev. 0
STEP 7
INSERTING/SECURING INTO
CABINET SURROUND
Ŷ Plug both units to the outlet in the wall.
Ŷ Find the installation string that is attached to the door
of the unit; this is to be used as you are pushing the
unit back into the opening. The string is attached to
the power cord; as you walk the unit back into the
opening you should pull the string tight to make sure
the power cord is routed underneath the unit.
Installation Instructions - Dual Retro-Fit Installation
WARNING
Electrical Shock Hazard.
To reduce the risk of electrical shock, be careful
during the remaining installation steps not to
touch wiring or electrical components inside the
compressor compartment while the appliance is
plugged in and the front access cover is not in
place.
Installation
String
STEP 6
CONNECTING WATER
SUPPLY
Ŷ Locate and bring the tubing to the front of the cabinet.
Ŷ Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
Ŷ Remove strain relief screw to allow for enough slack
to make a proper water connection. (Screw must be
replaced in the next step.)
Copper Tubing:
Ŷ Slip a 1/4” nut and ferrule (provided) over both ends
of the copper tubing. Insert the tube into the union
fitting on the unit and tighten the nut to the union.
Ŷ Turn on the water to check for leaks.
SmartConnect
™
Tubing:
NOTE: The only GE Appliances-approved plastic tubing
is supplied in the SmartConnect
™
Refrigerator Tubing
kits. Do not use any other plastic water supply line
because the line is under pressure at all times. Other
types of plastic may crack or rupture with age and
cause water damage to your home.
Ŷ Insert the molded end of the tubing into the
refrigerator or freezer connection. Tighten the
compression nut until it is just hand-tight.
Ŷ Follow the instructions provided with the tubing.
Overtightening can cause leaks!
Ŷ Turn on the water to check for leaks.
Strain Relief
Screw
AVERTISSEMENT
Risque
d’électrocution.
Afin de réduire le risque
d’électrocution, usez de prudence lors des étapes
d’installation suivantes afin de ne pas toucher au câblage
ou composants électriques à l’intérieur du compartiment
du compresseur une fois que l’électroménager est
branché sans le couvercle d’accès refermé.
ADVERTENCIA
Riesgo de Descarga
Eléctrica.
A fin de reducir el riesgo de descarga
eléctrica, tenga cuidado en los pasos restantes de la
instalación de no tocar el cableado ni los componentes
eléctricos dentro del compartimiento del compresor
mientras el electrodoméstico está enchufado y la tapa de
acceso frontal no está en su lugar.
Loading ...
Loading ...
Loading ...