Loading ...
Loading ...
Loading ...
12
31-1000600 Rev. 0
Installation Instructions - Reversing the Door Swing
STEP 5 REINSTALL HINGE
BRACKETS
Ŷ Move top hinge bracket to bottom and bottom bracket
to top.
Ŷ Ensure the 2 rectangular slots of bracket are on
outside, hinge side of case.
Ŷ Install both brackets with 3 T-30 Torx screws 45 in/lb
(5.1 Nm).
Ŷ Install the Phillips screw.
Ŷ Start 2 screws in
each bracket for
hinge mounting
but do not tighten
all the way.
STEP 6 REINSTALL THE
ENCLOSURE
Ŷ Install the enclosure assembly with removed six 1/4”
hex head screws.
Ŷ
Locate blue arrow on filter. Rotate filter to align arrow
as shown.
Rectangular
Slots
Screws for
Hinge Brackets
Housing Key Holes
STEP 4 MOVE LIGHT SWITCH
HOUSING (Cont.)
Ŷ Move the mounting bracket to the other side of the
unit by removing two Philips screws and using them
to install the bracket in its new location.
Ŷ Slide housing forward and down to remove from case
and grommets on case bottom.
Ŷ Keeping it connected to the unit, lay housing aside.
Ŷ Remove 2 grommets with Phillips driver.
Ŷ Move grommets to the set of 2 holes on opposite
side.
Ŷ Align housing key holes over grommets and then
slide back until engaged. Ensure wires do not get
pinched.
Ŷ Install Phillips screw into bottom hole to hold in place.
Grommets
Mounting
Bracket and
Screws
Phillips Screw
1/4” Hex Screws
Loading ...
Loading ...
Loading ...