Dahua ITC416-PL8I-IZ 4MP Access ANPR Camera

Smart ANPR Camera Web Operation Manual V1.0.0 - Page 35

For ITC416-PL8I-IZ.

PDF File Manual, 76 pages, Read Online | Download pdf file

ITC416-PL8I-IZ photo
Loading ...
Loading ...
Loading ...
27
Parameter Description
Barrier Opening Method
Triggers alarm through different modes, and remotely controls the
barrier opening and close.
All Vehicles Open Barrier
: When the camera captures any
vehicle, it outputs an open barrier signal.
Licensed Vehicles (Camera)
: When the camera captures any
plate, it outputs an open barrier signal.
Open barrier by allowlist
: When the camera captures vehicles
that are on the allowlist or conform to fuzzy matching, it
outputs an open barrier signal.
Command (Platform)
: The camera outputs an open barrier
signal when it receives a command from the platform.
Click
Manually open barrier
or
Manually Close
to manually
control the barrier.
You can set barrier opening control to
Open barrier by allowlist
,
and
Command (Platform)
at the same time.
Open barrier by
allowlist
takes priority.
Barrier Opening Config
Alarm-out Port
: Alarm linkage output port. You can select any
one of the 3 ports.
Duration
: The duration that the barrier opening or closing
signal lasts.
Barrier Closing
Step 3 Click
Save
.
2.5.1.6.2 Remote Controller
You can connect the camera to a remote controller, and then you can use the remote controller to
control the camera.
Procedure
Step 1 Select
Setting
>
ANPR
>
Barrier Control
>
Remote Controller
.
Step 2 Configure
Warning Light
and
Duration
.
If
Warning Light
is selected, when you press the unlock button on the remote control, the
light on the camera will flash for the duration you configure.
Step 3 Click
Connect
, and then press the corresponding button the remote controller.
You must press the button in 10 seconds.
Step 4 (Option) To disconnect the remote controller, click
Disconnect
.
Step 5 Click
Save
.
2.5.1.7 Configuring RS-485 Settings
You can configure RS-485 serial protocol of external devices. After configuration, you can set related
parameters of the device on the web client of the camera.
Procedure
Step 1 Select
Setting
>
ANPR
>
RS-485 Settings
.
Step 2 Configure the parameters.
The camera supports multiple protocols.
DHRS
Loading ...
Loading ...
Loading ...