Loading ...
Loading ...
Loading ...
www.kolpak.com 800-225-9916 30
Start at the base of the wall by fastening a plate into the top of the walk-in cooler
and into the wall of the adjacent building. Make sure at least 8” of material is up
the wall for proper termination. Work away from wall fastening 6” on center. The
1-1/2” screws should penetrate the top metal skin of the walk-in top panel.
If tapered roof system is used, the screw length will vary. Install the short screws
at the low side and increasingly longer screws toward the high side. Extra care
should be taken to only penetrate the top metal skin of the walk in top panel. Do
not penetrate the interior metal skin.
To prevent “Tab Rollover”, temporarily secure the edge of the overhanging roof
membrane to the top edge of the wall before continuing to the second tab
Unroll roof cap membrane to next tab and repeat the screw and fastening plate
pattern. Always pull slack out of membrane before starting a row of fasteners.
Use of GRiPull roof puller racket vice grip tool is ideal to keep material taut.
Loading ...
Loading ...
Loading ...