Loading ...
Loading ...
Loading ...
www.kolpak.com 800-225-9916 26
Electrical Connections
Consult the installation drawing supplied with the walk-in to determine which application
is required. Unless otherwise shown, the door section is furnished with a factory
installed vapor proof light fixture on the interior of the section, and a light switch with
pilot light indicator flush mounted on the exterior. All freezer door sections and cooler
doors with metal thresholds are equipped with anti-condensate heaters around the
entire perimeter. Heaters run underneath the thresholds, so care must be used if
drilling through so that the wire does not get damaged.
All wiring in the door and door section for heaters, switch, and light fixtures is factory
installed and requires only simple field connection for complete operation; typical
service required is 120 volt, 60 cycle, single phase, unless otherwise shown (consult the
installation drawing).
Electrical connections for the anti-condensate heaters are made on the interior of the
door section inside the fixture base of the vapor proof light. Consult the assembly
drawing for the specific electrical connection point for your unit.
CAUTION
Force sealant around wires in entrance conduit to prevent moisture from entering
fixture. Failure to eliminate airflow in conduit could void warranty.
For wiring diagrams, visit our website or scan the QR Code below.
Loading ...
Loading ...
Loading ...