Loading ...
Loading ...
Loading ...
intended and could result in additional
injury.
R
Objects or loads in the trunk/cargo com‐
partment cannot be restrained by the
seat backrest.
#
Make sure that the seat backrest and
the rear bench seat/rear seat are
engaged before every trip.
If the left and right seat backrests are not
engaged and locked in place, this will be shown
on the multifunction display of the instrument
cluster.
When installing a belt-secured child restraint
system, observe the following:
O
Always comply with the manufacturer's
installation and operating instructions for
the child restraint system used.
O
When using a category 0/0+ baby car
seat and a category I rearward-facing
child restraint system on a rear seat:
adjust the front seat so that the seat does
not touch the child restraint system.
O
When using a category I forward-facing
child restraint system: remove the head
restraint from the respective seat, if possi‐
ble.
After the child restraint system has been
removed, replace the head restraints imme‐
diately and adjust them correctly.
O
The backrest of the forward-facing child
restraint system must, as far as possible, be
resting on the seat backrest of the rear
seat.
O
For certain child restraint systems in weight
category II or III, there may be restrictions
on the maximum size setting, e.g. due to
possible contact with the roof.
O
The child restraint system must not be ten‐
sioned between the roof and the sitting sur‐
face and/or be installed facing the wrong
direction. Where possible, adjust the seat
cushion inclination accordingly.
O
The child restraint system must not be put
under strain by the head restraints. Adjust
the head restraints accordingly.
O
Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat forward slightly.
%
Before opening or closing the soft top, child
restraint systems in weight category II or III
must be removed or the head restraints of
the child restraint systems must be moved
to the lowest position. In this case, let the
child get out before opening or closing the
soft top.
The seat belts on the following seats are equip‐
ped with a special seatbelt retractor:
R
Front passenger seat
R
Rear seats
When enabled, the special seatbelt retractor
ensures that the seat belts of the front
passenger seat and rear seats do not slacken
once the child restraint system is secured
(/ page 57).
#
Install the child restraint system.
The entire base of the child restraint system
must always rest on the sitting surface of the
rear seat.
Occupant safety
61
Loading ...
Loading ...
Loading ...