Loading ...
Loading ...
Loading ...
"q_n" our TV remote can be set to
J. work your VCR or Cable
Converter by what is called the
SEARCH method.
If the "REMOTE CODE" number
method shown in the previous
section did not set your remote to
work your I,'C_ or Converter, then
_91low the easy steps listed below.
Please read through steps 1-4
before beginning.
Press the on
POWER
button
the VCR orConverter to turn theunit ON.
_' Stand at least six feet away
from the front of the VCR or
Converter.
Point the remote toward the unit.
HOLD DOWN the MCH and
Ihe desired System (VCR or
CBL-Converter) buttons at the
same time. KEEP HOLDING
BUTTONS DOWN.
<_ Watch the Channel Indicator
I n the unit.
Channel Numbers will SCAN UP
uhen the unit has been identified.
This may take up to two minutes.
Release the MCH and System
(VCR or CBL) buttons as soon
as channel numbers start to scan
up. The code has been identified
and the remote is ready to operate
with the VCR or Converter.
Remember, a minute or
two can seem very long, but
the code should be located within
two minutes.
Don't let the VCR or Converter
scan up more than five channels.
The remote may pass up the right
code and another two minute
search cycle will have to be
repeated.
If no channel change happens
within two minutes, repeat steps 1-
4. Should a channel change still
not occur, the remote will not
work with the desired unit.
CABLE CONVERTER
Don't let th_::N_R _eger
#
Remote will begin to beep when
the A/CH and VCR or CBL
System buttgns are pressed.
40
09
T
Six Feet
(minimum)
Loading ...
Loading ...
Loading ...