Loading ...
Loading ...
Loading ...
255
20.2: SERVICE BULLETIN # 41013861
EVAPORATOR REPLACEMENT KIT*
*THIS KIT DOES NOT FIT THE RF / RFI MODELS, SEE THAT BULLETIN LATER
IN THIS SECTION
Part number: 42249115, Evaporator Kit with Installation Instructions
REFER TO SECTION 3.6 FOR ADDITIONAL DISASSEMBLY INFORMATION
Reclaim Refrigerant from Sealed System
Reclaim the refrigerant in the sealed system per EPA regulations
Evaporator Removal
The evaporator heat exchanger is foamed in place in the back cabinet wall.
1. Cut the heat exchanger at the point it enters the foamed cabinet (behind
evaporator plate).
2. The suction line will also have to be cut at the point where it enters the foamed
cabinet from the machine compartment.
3. Remove the white foam evaporator spacers. Save as they will be used for the new
evaporator assembly.
4. Remove the evaporator and discard, caution of sharp edges from the cut tubing.
5. Unsolder suction line from compressor and discard, again use caution of sharp
edges surrounding cut heat exchanger.
6. Unsolder the liquid and capillary lines from the filter drier.
7. Drill a ½” hole in the left hand corner of the drain sump as close to the side wall as
possible. The hole must extend into the machine compartment.
8. Remove any sharp burrs on the top of the machine compartment created by the
drill bit.
Loading ...
Loading ...
Loading ...