Loading ...
Loading ...
Loading ...
217
19.4.9.2 Condenser Installation
1. Reattach the condenser to the two mounting brackets.
2. Ensure that the carriage bolts for mounting the condenser brackets are in place on
the bottom of the machine compartment.
3. Install and solder the discharge and liquid lines to condenser.
4. Carefully slide the base assembly back in place.
5. Reconnect any electrical harnesses disconnected previously.
6. Install and solder a new filter drier in the system.
7. Evacuate, charge to serial plate recommendation, and leak check the sealed system.
8. Carefully reconnect all electrical terminals back on the terminal board.
9. Secure base assembly to cabinet at rear and front locations.
10. Reconnect the components that were disconnected earlier.
a. “Y” connector – secures and tightens all hose clamps.
b. Drain valve – secure and tighten all hose clamps.
c. Fill valve.
d. Door sensor switch and any other harnesses disconnected.
This 3/8”nut and star washer
should not have to be
removed. The condenser will
slide in and out of this
bracket.
Remove the 3/8” nut and star
washer.
Loading ...
Loading ...
Loading ...