Loading ...
Loading ...
Loading ...
218
19.4.10 Evaporator:
The evaporator removes heat from water cascading over the plate, ultimately making a full bin
of ice within 24 hours (undisturbed cycle). The evaporator plate is “U” shaped in appearance
and is installed in the top section of the ice machine behind the escutcheon cover.
19.4.10.1 Evaporator Removal
1. Disconnect power to the unit.
2. Remove both rear top and bottom access panels.
3. Install sealed system access valves and evacuate and recover refrigerant.
4. Unsolder the suction line, hot gas line, and capillary tube from the filter drier.
5. Remove the appliance door to ease the removal process.
6. Remove the following components from inside the ice machine;
Escutcheon cover
Ice deflector
Water deflector
Grid cutter
Water distribution tube
7. Remove the four Philips pan head screws (See photo above).
8. Remove all the insulation from the bun hole.
9. Straighten out the disconnected tubing and pull the evaporator and tubing out from
the inside and discard assembly.
(4) Philips pan head
screws, 2 on each side,
front and rear of the
evaporator flange.
Loading ...
Loading ...
Loading ...