Loading ...
Loading ...
Loading ...
4 Configuration D-Link Smart Managed Switch User Manual
7
7
9
9
Figure 4.105 – Security > Smart Binding > Smart Binding
The Manual Binding Settings contains the following fields:
From Port / To Port: Specify the switch port ranges for which to configure this IP-MAC binding entry (IP
Address + MAC Address).
IP Address: Specifies the IP address to bind to the MAC address set below.
MAC Address: Specifies the MAC address to bind to the IP address set above.
Click Add to add a new entry.
Auto Scan: The Auto Scan Setting can list connected devices and easily select to bind. It contains the
following fields:
IP Address From/To: Specifies the range of IP Address to find desired devices, or leaves the fields blank to
see all connected devices.
Click Scan and the search results will be listed in below table.
Binding: check the box to select desired binding devices.
Apply: click Apply to set IP-MAC-Port Binding entries.”
Select All: to check the boxes of Binding for all found devices.
Clear All: to cancel the box of Binding
Security > Smart Binding > White List
When IP +ARP Inspection Mode is selected, the White List page displays finished IP-MAC-Port Binding
entries from page Smart Binding. Only IP packets or ARP packets carrying matched IP-MAC-Port
information can access to the switch. You can cancel a device’s authorization by deleting it from the table.
Figure 4.106 – Security > Smart Binding > White List
Select the check box of entry then click Delete to remove it.
Click Select All to select all entries of the table or click Clean to select none entries. Please keep at least
one management host in the White List.
Security > Smart Binding > Black List
The Black List page shows unauthorized accesses. When ARP Inspection is selected and a device sends
out an ARP packet containing unmatched IP-MAC-Port information, the device will be forbidden and listed
here.
Loading ...
Loading ...
Loading ...