Loading ...
Loading ...
Loading ...
5 Command Line Interface D-Link Smart Managed Switch User Manual
108
To configure the firmware image id 1 to be used when boot up on the Switch:
DGS-1210-52MPP> config firmware image_id 1 boot_up
DGS-1210-52MPP>
config ipif system
Purpose To configure the System IP interface.
Syntax
config ipif system { ipaddress <ip-address> <subnet-mask>
gateway <gw-address> | dhcp | bootp }
Description
The config ipif system
command configures the System IP
interface on the Switch.
Parameters
ipaddress <ip-address> <subnet-mask> −
The IP address and
subnet mask to be created. Users need to specify the address
and mask information using the traditional format (for
example,10.1.2.3/255.0.0.0)
gateway <gw-address> −
The IP address of the router or
gateway.
dhcp − Allows the selection
of the DHCP protocol for the
assignment of an IP address to the Switch’s System IP interface.
bootp − Allows the selection of the BOOTP to the switch.
Restrictions None.
Example usage:
To configure the IP interface System:
DGS-1210-52MPP> config ipif System ipaddress 10.48.74.122/8
Success.
DGS-1210-52MPP>
config ipif system
Purpose To configure the System IPv6 interface.
Syntax
config ipif system { ipv6 ipv6address <ipv6networkaddr> |
dhcpv6_client [enable | disable] }
Description
The config ipif system command configures the System IPv6
interface on the Switch.
Parameters
ipv6 ipv6address <ipv6networkaddr> −
Use this parameter to
statically assign an IPv6address to this interface. This address
should define a host address and a
network prefix length.
Multiple IPv6 addresses can be configured for a
single IP
interface. Ex: 3ffe:501:ffff:100::1/64. The /64 represents the prefix
length of the IPv6 addresses.
dhcpv6_client [enable | disable] − Specify the DHCPv6 client to
be disabled or enabled.
Restrictions None.
Example usage:
To configure the IPv6 interface System:
Loading ...
Loading ...
Loading ...