Loading ...
Loading ...
Loading ...
1211
Electrical Connection
INSTALLATION
Installing the Oven
INSTALLATION
instructions, local gas tting regulations, municipal building codes,
to avoid oor damage.
Feed the exible electrical supply conduit from the oven to the
STEP 3 - INSTALL OVEN
1. Using two or more people, grasp the ceiling of the oven cavity and lift the oven
onto a table or platform even with the cutout opening. NOTE: The surface must
be able to support 160 lb (73 kg).
2. Feed the flexible electrical supply conduit from the oven to the junction box.
STEP 4 - MAKE ELECTRICAL CONNECTION
To properly install your oven, you must determine the type of electrical connection
you will be using and follow the instructions provided for it here.
ELECTRICAL SHOCK HAZARD
DIRECT WIRE
• Disconnect power before servicing.
• Improper connection of aluminum house wiring and copper appliance leads can
result in an electrical hazard or re. If the home has aluminum wiring, only use
connectors designed and UL listed for joining copper to aluminum and precisely
follow the manufacturer’s recommended procedure. Aluminum-to- Copper
connections must conform with local codes.
• Use 8 gauge copper or aluminum wire.
• Electrically ground oven.
• Failure to do so can result in death or electrical shock.
• Be sure your appliance is properly installed and grounded by a qualified
technician. Ask your dealer to recommend a qualified technician or an
authorized repair service.
• This oven is manufactured with a neutral (white) power supply wire and a
cabinet connected green (or bare) ground wire twisted together.
• After making sure that the power has been turned off, connect the flexible
conduit from the oven to the junction box using a UL listed conduit connector. The
Grounded Neutral and Ungrounded Neutral Graphics on the following pages
and the instructions provided, present the most common way of connecting
ovens. Your local codes and ordinances, of course, take precedence over these
instructions. Complete electrical connections according to local codes and
ordinances.
1. Disconnect power.
2. Remove junction box cover.
3. Install a UL listed or CSA approved conduit connector to the junction box.
4. Route the flexible electrical supply conduit from the oven to the junction box
through a UL listed or CSA approved conduit connector.
5. Tighten screws on conduit connector.
WARNING
qualied technician. Ask your dealer to recommend a qualied
technician or an authorized repair service.
the exible conduit from the oven to the junction box using a UL
UL or CSA Listed Conduit Connector
Route the exible electrical supply conduit from the oven to
Failure to do so could result in death, re or electric shock.
UL or CSA Listed Conduit Connector
Loading ...
Loading ...
Loading ...