Loading ...
Loading ...
Loading ...
SWITCH LOCK
Refer to Figure 13.
The planer/molder can be lockedfrom unauthorized
use by lockingthe switch.To lockthe switch:
• Turn the switch to OFF positionand disconnectplan-
er/molder from power source.
• Pull the key out.The switchcannotbe turned on with
the key removed.
NOTE: Should the key be removedfrom the switch at
the ON position,the switchcan be turned off but cannot
be turned on.
• To replace key,slide key intothe sloton switch until
itsnaps.
For precise movement, rotate handle with knob.One
complete rotationof handle willraise or lower renercase
by 1/16"(see Figure 15).
A rotationaldirectionlabelwith depth indicatorislocat-
ed under the handle.
Figure 13 - Removing Locklng Key
RAISING AND LOWERING ROLLERCASE
Refer to Figures 14 end 15.
The rollercasecontains the motor,cutterhead and dust
collector.The depth-of-cut is controlled by raisingor
loweringthe rollercase. For rapid movementof the
rollercase, pushup or down on powerelevation lever
while motor is running(see Figure 14).
WARNING: Do notattempt to engage powerelevation
while planing.Keep hands clear of knobon top of
planer/molder.
Figure 14 - Power Elevation and Feedrate Controls
Figure 15 - Manually Raising or Lowering the Rollercase
FEED RATE ADJUSTMENT
Refer to Figure 14.
• The planer/molder has a 2-speed gearbox that feeds
the workpiece at 22 feet per minute(standard plan-
ing) and at 11 feet per minute(for moldingor finish
planing).
Finish planinga workpiece resultsin a better surface
finish than that obtained byplaning at the higher
speed.
• The knobfor adjustingthe feed rate is locatedon the
left side of the top ofthe mllercese.
NOTE: Only change feed rate while the machine is
running.
DEPTH-OF-CUT GAUGE AND SCALE
Refer to Figure 16, page 9.
A depth-of-cutgauge is attached to the frontof the
rellercase.The pointeron the depth-of-cutgauge accu-
ratelydisplays the depth-of-cutper passwhen work-
piece is positionedbelowthe gauge. Crankingthe han-
dle moves the mllercase down and the pointershows
depth-of-cutup to 3h=".
Recommended Maximum Depth-Of-Cut:
Hard/Softwood up to 8" wide:.................. 3/_,,
Hard/Softwood 8" to 15" wide: ................... 1/_,,,
The English/Metricscale with pointerallowseasy
adjustment of rollercase height.This scale indicates
the finishedsize ofthe workpiece.
8
Loading ...
Loading ...
Loading ...