Loading ...
Loading ...
Loading ...
46
VALVE "LOW" SETTING ADJUSTMENT
Stability of the "low" setting on main burners, and infrared
burners may vary due to wind direction, grill configuration, and
grill position. If your burner goes out when set on low, the valve
"low" setting needs adjustment.
Note: Adjustments MUST only be performed by a qualified
professional service technician.
Important: The valve "low" setting for the backburner
must remain at the factory setting. It is
recommended to only use the backburner at
a medium to high setting.
To adjust the valve "low" setting:
1. Ensure the unit is completely cool and the knobs are
in the OFF position.
2. Remove the cooking grids and flavor grids.
3. Light the burner on HIGH, then turn the burner to LOW
setting. While the burner is lit, remove the control knob
from the valve.
4. Locate the FLATHEAD adjustment screw found inside the
valve stem (see Fig.
46-1).
5. Using a flathead screwdriver, slowly turn the adjustment
screw a little at a time (30° to 45°) in either direction. Adjust
the screw as needed until the flame is approximately
1
/4" in
height from all the burner ports, and the flames are stable.
6. Once the appropriate setting is reached, re-install the
control knob and shut off the burner valve.
7. Repeat this procedure for other burner valves, if needed.
8. Re-install the control panel, flavor grids, cooking grids, and
any other components that were removed.
Fig. 46-3 Valve adjustment screw location
Adjustment screw
(inside valve stem)
(Manifold)
SERVICING AND CLEANING (Cont.)
Loading ...
Loading ...