Loading ...
Loading ...
Loading ...
21
INSTALLATION
It is not required to remove the control panel or knobs to
install this unit.
DO NOT lift the unit from the control panel when installing.
COUNTER PREPARATION
Consult Table 3 for non-combustible enclosure cutout dimensions.
An RHP insulating liner must be used if any supporting
construction is combustible. Consult the instructions that come
with the liner for dimensions and additional installation information
before beginning the installation.
This outdoor built-in grill must be supported by the stainless-steel
hanger extending from the upper portion of the grill. The hanger
rests on the left, right, and back of the countertop and on the two
front support adjustment bolts located below the control panel
on the left and right sides (see Fig. 21-3).
The control panel is designed to sit flush against the enclosure
front wall (see Fig. 21-1). If the non-combustible enclosure
countertop extends beyond the front wall, creating a countertop
overhang (see Fig. 21-2), it must be cut flush with the front
wall for the width of the control panel or a gap will be created
exposing the forward portions of the left and right side grill fire
walls. Reference the MODEL SPECIFICATIONS section.
SLIDE THE UNIT INTO THE ENCLOSURE CUTOUT
1. Carefully slide the unit into the cutout in the enclosure.
Important: Ensure the electrical and gas connections are
clear, undamaged, and completely inserted
into the opening, and that the unit is correctly
inserted without any obstructions between it
and the countertop.
2. Rotate the front support adjustment bolts to the left to raise
and to the right to lower the respective side of the appliance.
Use a
7
/16" open-end wrench as needed. See Fig. 21-3.
Important: The bolts MUST be used to provide support
to the hangers.
INSTALLATION
Front
support
adjustment
bolt
Bottom of face
Bottom
of cut-out
opening
Fig. 21-3 Front support adjustment bolts
IDEAL
Flush-mounted
control panel
Countertop
Overhang
Fig. 21-1 Countertop overhang - correct cutout
CORRECT
GAP CREATED
Proposed cut-out
in overhang
Countertop
Control panel
stops here
INCORRECT
Fig. 21-2 Countertop overhang - incorrect cutout
Front
support
adjustment
bolt
Bottom of
face
Bottom
of cut-out
opening
Loading ...
Loading ...
Loading ...