Loading ...
Loading ...
Loading ...
22
CONNECT THE GAS SUPPLY
To Connect To Propane Cylinder:
Read the safety warnings and follow the instructions in the
section SAFE USE AND MAINTENANCE OF PROPANE GAS
CYLINDERS.
Note: When a propane cylinder is installed inside of
the enclosure, the guidelines found in the GRILL
ENCLOSURE / VENTILATION REQUIREMENTS
section MUST be followed.
To Connect To Natural Or Household Propane Gas Supply:
CAUTION: Use only C.S.A. listed stainless-steel flex
connectors within the enclosure.
WARNING
A rubber or plastic connector will rupture or leak, resulting
in an explosion or serious injury if used inside the appliance
enclosure.
• Before connecting the gas supply to your appliance,
pressures MUST be tested and MUST NOT exceed 10.5"
w.c. for Nat. gas and 13" w.c. for L.P. gas. An additional
regulator may be required.
• Refer to the GAS SUPPLY PLUMBING REQUIREMENTS
section for all details on the gas supply and its setup.
1. Turn OFF the gas supply at the source.
2. Run the attached flex connector routed under the middle
of the grill to the gas supply stub.
3. A shut-off valve is required within 6 feet of the unit and must
be easily accessible.
If shut-off valve is installed in-line:
• Install the supplied flare-to-NPT adapter to the gas supply
(NPT) using a pipe joint compound resistant to all gasses
(see Fig. 22-1, A). Tighten securely.
• Connect the flex connector to the adapter (see Fig. 22-1,
A). Tighten securely.
If shut-off valve is connected to end of gas supply stub:
• Connect the flex connector to the shut-off valve (flare)
(see Fig. 22-1, B). Tighten securely.
LEAK TEST
Turn all burner valves to the OFF position. Turn on the gas
supply, and test at all connections for leaks using a soapy
water solution. If bubbles appear, a leak is present. Turn off the
gas and tighten at all connections. Repeat until no leaks are
present. If a leak persists, turn off the gas supply and contact
the local gas company or dealer. NEVER USE A FLAME TO
CHECK FOR LEAKS.
Once the leak test is complete, turn off the gas supply and
proceed.
Fig. 22-1 Connecting to a gas line
Gas supply
(NPT)
Flex
connector
(from grill)
Flare-to-NPT
shut-off
valve*
(end of gas
supply)
NPT-to-NPT
shut-off
valve*
(in-line)
Gas supply
(NPT)
Flare-to-NPT
adapter
Flex
connector
(from grill)
* Shut-off valve: required, not included, must be within
6 feet of unit and must be easily accessible.
A B
-OR-
INSTALLATION (cont.)
Hanger
Flex
connector
Flare-
to-NPT
adapter
gas supply
(NPT)
OFF
Gas supply
(NPT)
Shut-off valve (shown in-line)
must be within 6 feet of the unit
and must be easily accessible.
(Countertop)
Fig. 22-2 Household LP & Nat. gas diagram
Loading ...
Loading ...
Loading ...