Fire Magic H790I8L1NW User Manual

Loading ...

POWER SUPPLY

The electrical connections from the power supply box to

the unit come pre-connected.

CAUTION: IMPROPERLY CONNECTED WIRES WILL

CAUSE DAMAGE TO THE UNIT AND MAY

RESULT IN PROPERTY DAMAGE AND/OR

PERSONAL INJURY.

To install the power supply box:

1. Route the wire harness extension below the control panel

and directly downward. This will prevent overheating.

DO NOT route the wire extension below the grill.See

Fig. 25-1, A.

Note: For enclosures with a solid area beneath the grill,

a cutout must be made near the wire extension to

allow for the above requirement. If an insulating

liner is installed, route the wire down through the

nearest hole possible.

2. Mount the power supply box to the inside of the enclosure

using appropriate hardware for your enclosure. It MUST

be located at least 12 inches below the bottom of the

unit. See Fig. 25-1, B.

WARNING: DO NOT block the vent holes found on the

box.

3. Connect the cord coming from the power supply to a

120VAC (15 AMP minimum) GFCI GROUNDED 3-wire

receptacle

(see Fig. 25-1, C). The GFCI receptacle

must be a WEATHER-PROOF IN-USE COVERED

RECEPTACLE.

WARNING: Electrical Grounding Instructions - This

appliance is equipped with a three-pronged

(grounding) plug for your protection

against shock hazard and should be

plugged directly into a properly grounded

three-prong receptacle. Do not cut or

remove the grounding prong from this

plug.

If side cookers are to be installed and will be powered

using the same grill power supply, instead refer to the

POWER SUPPLY / WIRE HARNESS CONNECTIONS

section of the owner's manual included with the side

cooker for power supply installation.

Fig. 25-1 Electrical installation

12"

Min.

Route wires

directly

downward

(to prevent

overheating)

1. Locate power supply box

2. Route wire harness extension downward

3. Mount power supply box

4. Connect cord to power source

120VAC (15 AMP minimum) GFCI

GROUNDED 3-wire receptacle

12"