Loading ...
Loading ...
Loading ...
29
SHUTTING OFF THE UNIT
To shut off the unit, depress each valve control knob
and while pressing turn it clockwise to the OFF position.
Always close the valve from the gas supply after each
use of the unit.
ELECTRONIC LIGHTING
Note: Electronic lighting requires an installed 9-volt
battery with a good charge.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
Note: DO NOT
turn on more
than one valve at
a time for either
electronic or
manual lighting.
4. Depress the desired control knob for 5 seconds.
Ensure the igniter is glowing (inside of lighting tube),
then, while pressing turn the knob counterclockwise
to the HI LIGHT position. Once the burner lights,
release the knob.
CAUTION: If a burner does not light within five (5)
seconds of turning on the control knob,
depress the knob and turn it to the OFF
position. WAIT FIVE (5)
MINUTES
before repeating step 4. If you smell
gas, follow the instructions on the cover
of this manual. If the burners still do not
light after several attempts, refer to the
instructions for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
Read all instructions before lighting, and follow these instructions each time you light the unit.
Fig. 29-2 - Manual lighting
Lighting
tube
Lighter
WHEN USING A PORTABLE PROPANE TANK
Propane tanks are equipped with a safety shutdown
device that may cause low or no gas pressure/flame
at the burners if operating and lighting instructions
are not followed exactly (See important note in the
TROUBLESHOOTING section for more details.)
MANUAL LIGHTING
CAUTION: Always wait five (5) minutes for gas to
clear after any unsuccessful lighting
attempt.
1. Follow steps 1 through 3 (left).
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid
opening to the top of the lighting tube (Fig. 29-2). For
backburners, hold the flame against the surface of
the backburner.
For sideburners, hold the flame against the burner.
3. Hold the match / lighter flame at the top of the lighting
tube for 5 seconds, or, next to the sideburner /
backburner. Then depress the appropriate control
knob and while pressing turn it counterclockwise to
the HI LIGHT position. Remove the lighter or match
when the burner lights, and release the control knob.
4. If the burner does not light within five (5) seconds
of turning the control knob, immediately depress
the knob and turn the valve to OFF. WAIT FIVE
(5) MINUTES before repeating steps 2 through 4 of
the MANUAL LIGHTING instructions.
Fig. 29-1 Control knob
OFF
HI
LIGHT
LOW
TO
TURN OFF
TO TURN ON
Read setting
here
HIGH to
LIGHT
Read setting here
(OFF position shown)
To Turn OFF
To Turn ON
Use
HI (high)
to light
Press
knob in
to turn
Gas Flow
Indicator
For your convenience and safety; when the
control knob is turned to the on position, the gas
flow indicator will change from blue to red. (Red
indicates gas flow.) See Fig. 29-1.
MANUAL LIGHTING
CAUTION: Always wait five (5) minutes for gas to
clear after any unsuccessful lighting
attempt.
1. Follow steps 1 through 3 (left).
2. Insert either a burning long-barrel butane lighter or
a burning long-stem match through the cooking grid
opening to the top of the lighting tube (see Fig. 29-2).
For backburners or infrared burners, hold the flame
against the surface of the backburner/infrared burner.
Grills equipped with an infrared burner include a
wire extension match holder (attached to drip tray)
to assist with manual lighting (see Fig. 29-3).
3. Hold the match / lighter flame at the top of the lighting
tube for 5 seconds, or, against the backburner/
infrared burner. Then depress the appropriate control
knob and while pressing turn it counterclockwise to
the HI LIGHT position. Remove the lighter or match
when the burner lights, and release the control knob.
4. If the burner does not light within five (5) seconds
of turning the control knob, immediately depress
the knob and turn the valve to OFF. WAIT FIVE
(5) MINUTES before repeating steps 2 through 4 of
the MANUAL LIGHTING instructions.
Fig. 29-2 Manual lighting
via lighting tube
Lighting
tube
Lighter
Match holder w/ match
Fig. 29-3 Manual lighting
via match holder
Insert through opening and hold
flame against burner surface
Fig. 29-2 Manual lighting
via lighting tube
Lighting
tube
Lighter
Fig. 29-3 Manual lighting
via match holder
Match holder w/ match
Insert through opening and hold
flame against burner surface
Note: This unit must be connected to 120VAC power
for electronic lighting.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source and press the master
switch.
After each use, always close the valve from the gas
supply and shut off the master switch.
LIGHTING (IGNITION) INSTRUCTIONS
Loading ...
Loading ...
Loading ...