Loading ...
Loading ...
Loading ...
DMX Operator 384 Editing Chases
ADJ Products, LLC - www.adj.com - DMX Operator 384 User Manual Page 16
DELETE A CHASE
(1) Press and hold down the Program button for approximately 2 seconds or until the PROG indicator in
the LED display ashes. Once the indicator is ashing, record mode is engaged and you may
release the Program button.
(2) Select the Chase # button, 1-12, that you want to delete.
(3) Simultaneously, press the Auto/Del button then press the same Chase # button that you selected
in step 2. All LED’s should ash three times to conrm that the chase was deleted.
(4) Repeat steps 2 & 3 to delete additional scenes.
(5) Press and hold down the Program button for approximately 2 seconds or until the PROG indicator
in the LED display stops ashing. A ashing Blackout indicator, in the LED display, is indicative
that you are out of program mode.
DELETE ALL CHASES
(1) Flip the Operators power switch OFF which is located at the rear of the unit.
(2) Simultaneously, press and hold down the Auto/Del and Bank Down buttons and
ip the power switch ON.All LED’s will ash three times to conrm that all chases
were deleted.
1. MANUAL TRIGGER:
(1) When powered ON, this console defaults to Manual/Blackout mode. All output will be in a blackout
state until the Blackout button is deselected. To determine blackout status there is an indicator
light in the display that ashes when engaged and OFF when disengaged. Press the Blackout
button so the indicator stops ashing.
(2) Press the Chase # button, 1-12, that you want to playback. The selected chase LED should
illuminate.
(3) Press the BANK UP & DOWN buttons, as desired, to manual step through your chase steps. You
can also manually adjust the Fade Time fader if you wish to incorporate a crossfade between
step.
(4) Repeat steps 2 & 3 to manually playback additional chases.
DMX Operator 384 Chase Playback
Loading ...
Loading ...
Loading ...