ADJ DMX OPERATOR-384 User Manual

Loading ...

ADJ Products, LLC - www.adj.com - DMX Operator 384 User Manual Page 8

DMX Operator 384 Joystick Set Up

ASSIGN JOYSTICK REVERSE (PAN/TILT INVERT)

(1) Press and hold down the Program button for approximately 2 seconds or until the PROG indicator

in the LED display ashes. Once the indicator is ashing, record mode is engaged and you

may release the Program button.

(2) Press and hold down the MODE button and then tap the FINE button. The “Assign” and “Pan”

LED’s should illuminate.

(3) Once again, press and hold down the MODE button and then tap the FINE button. The “Reverse”

LED should illuminate

(4) Select the xtures that you wish to assign the “Pan Reverse” & “Tilt Reverse” for by pressing the

FIXTURES # buttons, 1-12, so the selected xture LED’s illuminate. Ideally, you should assign

opposite xtures for Pan/Tilt Reverse. For example, xtures 1, 3, 5, 7, etc... should be assigned

normal as described in the previous section and xtures 2, 4, 6, etc..., should be assigned

reversed so that when moving the joystick around, xtures movements are reversed from one

another. This feature is traditionally referred to as Pan/Tilt invert.

(5) Press the Tap/Disp button to switch between “PL.XX” & “PH.XX”. “PL.XX” represents the Low

Byte or Fine channel, generally listed as the Pan Fine channel and PH.XX represents the High

Byte or Coarse channel, generally listed as the Pan channel. Set it to “PH.XX” and press and hold

down the MODE button and then tap the SCENE button that corresponds to the Pan channel

of your xture. For example, if your xtures Pan channel is 1 then you’d press the SCENE #1

button. Please refer to the xtures DMX chart. If your xture includes a pan ne channel, press

the Tap/Disp button so the display reads “PL.XX”. Press and hold down the MODE button and

then tap the SCENE button that corresponds to the Pan Fine channel of your xture. For example,

if your xtures Pan Fine channel is 2 then you’d press the SCENE #2 button.

(6) Press the BANK UP or DOWN buttons to switch between “TL.XX” & “TH.XX”. “TL.XX” represents

the Low Byte or Fine channel, generally listed as the Tilt Fine channel and TH.XX represents the

High Byte or Coarse channel, generally listed as the Tilt channel. Set it to “TH.XX” and press and

hold down the MODE button and then tap the SCENE button that corresponds to the Tilt channel

of your xture. For example, if your xtures Tilt channel is 3 then you’d press the SCENE #3

button. Please refer to the xtures DMX chart. If your xture includes a Tilt Fine channel, press the

Tap/Disp button so the display reads “TL.XX”. Press and hold down the MODE button and then

tap the SCENE button that corresponds to the Tilt Fine channel of your xture. For example, if

your xtures Pan Fine channel is 2 then you’d press the SCENE #4 button.

(7) Press and hold down the Program button for approximately 2 seconds or until the PROG indicator

in the LED display stops ashing. A ashing Blackout indicator in the LED-display conrms that

the controller is out of Program mode.

Loading ...

ADJ DMX OPERATOR-384 Products, , 384 Channel DMX 512 with 12 Chase Programs and 8 Faders