Loading ...
Loading ...
Loading ...
2.15.3 CAPACITOR
1. Remove the control box. (Refer to section 2.13.3)
2. Remove the screw and knobswhich fasten the
display panel.
3, Disconnect the 2 leads from the rocker switch and
remove the panel.
4. Remove a screw and unfold the control box.
(See Figure 67)
5. Remove the screw and the clamp which fastens
the capacitor.
6. Disconnect all the leads of capacitor terminals.
7. Re-install the components by referring to the
removal procedure, above.
Figure 67
2.15.4 POWER CORD
1. Remove the control box. (Refer to section 2.13.3)
2. Unfold the control box. (Refer to section 2.15.3)
3. Disconnect the grounding screw from the control
box.
4. Disconnect 2 receptacles.
5. Remove a screw which fastens the clip cord.
6. Pull the power cord. (See Figure 68)
7. Re-install the component by referringto the
removal procedure, above.
(Use only one ground-marked holeO for ground
connection.)
8. If the supply cord of this appliance is damaged, it
must be replaced by the special cord.
(The special cord means the cord which has the
same specification marked on the supply cord fit-
ted to the unit.)
Figure 68
2.15.5 THERMOSTAT
1. Remove the control box. (Refer to section 2.13.3)
2. Unfold the control box. (Refer to section 2.15.3)
3. Remove the 2 screws whichfasten the thermostat.
4. Disconnect all the leads of thermostat terminals.
5. Remove the thermostat. (See Figure 69)
6. Re-install the components by referring to the
removal procedure, above.
Figure 69
--28---
Loading ...
Loading ...
Loading ...