Loading ...
Loading ...
Loading ...
• MODEL: 79184/79188
-- Before the following disassembly, POWER SWITCH is set to OFF and disconnected the power cord.
2.13 MECHANICAL PARTS
2.13.1 FRONT GRILLE
1. Open the inlet grille downward.
2. Remove the screw which fastens the front grille.
3. Pull the front gdlle from the dght side.
4. Remove the front gdlle. (See Figure 57)
5. Re-install the component by referring to the
removal procedure.
Figure 57
2.13.2 CABINET
1. After disassembling the front gdlle, remove the
screws which fasten the cabinet at both sides.
2. Remove the two screws which fasten the cabinet
at back. (See Figure 58)
3. Pull the base pan forward.
2.13.3 CONTROL BOX
1. Remove the front gdlle. (Refer to section 2.13.1 )
2. Pull the base pan forward so that you can remove
the 2 screws which fasten the cover control at the
dght side. (See Figure 59)
3. Remove the 3 screws which fasten the control
box. (See Figure 59, only for 79188)
4. Discharge the capacitor by placing a 20,000 ohm
resistor across the capacitor terminals.
5. Disconnect two wire housings in the control box.
6. Pull the control box forward completely.
7. Re-install the components by referring to the
removal procedure.
(Refer to the circuitdiagram found on pages
51_52 in this manual and on the control box.)
Figure 58
Figure 59
--25---
Loading ...
Loading ...
Loading ...