Loading ...
Loading ...
Loading ...
2.2.3 AIR GUIDE AND MOTOR
1. Disconnect the unit from the power source.
2. Remove the front grille. (Refer to Section 2.1.1)
3. Remove the cabinet. (Refer to Section 2.1.2)
4. Remove the control board.
(Refer to Section 2.1.3)
5. Remove the orifice. (Refer to Section 2.2.1 )
6. Remove the compressor, evaporator and
condenser. (Refer to Section 2.2.2)
7. Remove 2 screws that secure the motor to the air
guide. (See Figure 10)
8. Separate the motor by pulling it backward.
9. Remove 2 screws that secure the air guide to the
base fan. (See Figure 11)
10. Push the air guide backward and lift it upward.
(See Figure 11)
11. Re-install by referring to the procedures above.
Figure 10
Figure 11
2.3 ELECTRICAL PARTS
2.3.1 OVERLOAD PROTECTOR
1. Remove the cabinet. (Refer to Section 2.1,2)
2. Remove the nut which fastens the terminal cover.
3. Remove the terminal cover.
4. Remove all the leads from the overload protector.
5. Remove the ovedoad protector.
6. Re-install the components by referring to the
removal procedure above.
(See Figure 12 and 13)
Figure 12 Figure 13
--11--
Loading ...
Loading ...
Loading ...