Loading ...
Loading ...
Loading ...
2.10.3 SHROUD
1. Remove the fan. (Refer to section 2.10.2)
2. Remove the screw which fastens the shroud.
3. Remove the shroud. (See Figure 47)
4. Re-install the component by referring to the
removal procedure, above.
2.11 ELECTRICAL PARTS
2.11.1 OVERLOAD PROTECTOR
1. Remove the cabinet. (Refer to section 2.9.2)
2. Remove the nut which fastens the terminal cover.
3. Remove the terminal cover. (See Figure 48)
4. Remove all the leads from the ovedoad protector.
5. Remove the overload protector.
6. Re-install the component by referring to the
removal procedure, above.
Figure 47
Figure 48
2.11.2 COMPRESSOR
1. Remove the cabinet. (Refer to section 2.9.2)
2. Discharge the refrigerant system using a Freon_
Recovery System.
If there is no valve to attach the recovery system,
install one (such as a watco a-l) before venting
the FreonTM.Leave the valve in place after
servicing the system.
3. Remove the overload protector. (Refer to section
2.11.1)
4. After purging the unit completely, unbraze the suc-
tion and discharge tubes at the compressor con-
nections.
5. Remove the 3 nuts and the 3 washers which
fasten the compressor.
6. Remove the compressor. (See Figure 49)
7. Re-install the components by referring to the
removal procedure, above.
Figure 49
--22D
Loading ...
Loading ...
Loading ...